|
|
#1
2nd January 2011, 03:28 PM
|
|||
|
|||
Rear upright orientation
Just about to weld RU7 in to my upright. If it's welded in square it looks like the handbrake cable might not fit so I was thinking of welding it in off centre. That way the handbrake hole is accesible and the plastic stop can be reached from the side. I had to file a little bit of the side plate to clear the handbrake hole bulge. Anyone else come across this problem and how did you do it?
  
__________________
Total cost so far Materials £3,150 Tools £855 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode