Megajolt connector pins

[mark]

Originally Posted by mikemph

Normal there spare ports which you can configure to output a signal when certain conditions are met.

For example you could get the vvt to operate when rpm>3000 and tps>50% that way the vvt will not be kicking everytimethe revs get over 3000. But will when you give half throttle and revs go over 3000

This purely an example but is a good method to set it up something like this. You could use calculated load instead of throttle position.

I was just going to set it at a certain rpm limit but that sounds a better option to use load or tps aswell