|
|
#2
18th February 2011, 05:35 PM
|
|||
|
|||
Sam
pull pulley off the pump get the centre of the pulley bored out to take a boss get a pair of cheap sealed bearings get them pressed in the boss make up a plate to sit where the pump was get a spindle turned to fit the inner dimension of your bearings threaded on the end get the spindle welded to the plate or if the plate is thick enough drill and tap plate and have thread on both ends of the spindle and screw spindle into plate and secure with locnut/threadlock now you can shim pulley in and out to allign and secure with a spacer and nut on other end of pulley cheers les g 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode