the ecu

[misty]

prob carbs i hope

[twinturbo]

if you have a hunt on my website you will find a spreadsheet about loom plugs, it was intended to help with fitting a granada 24v in a sierra but it lists the engine hookup plugs and their function.

You will need to register.

TT

[tex]

if your using carbs there is no wiring or ecu is there not?
the engine uses coil and points - points can be replaced with optical

[jasongray5]

Depends on yourset up,
If your using something to controll your spark, say, megajolt, then you need wires to the TPS, air temp, coolant temp.
But if you were to use a dizzy, then no, no wiring?
(I probably havent made that very clear)
Hope it helps abit

[twinturbo]

if your using carbs there is no wiring or ecu is there not?
the engine uses coil and points - points can be replaced with optical

Depends on yourset up,
If your using something to controll your spark, say, megajolt, then you need wires to the TPS, air temp, coolant temp.
But if you were to use a dizzy, then no, no wiring?
(I probably havent made that very clear)
Hope it helps abit

Not so, all sierras have at the very very minimum had transistorized ignition amplification. Most carb models run a variation on ESC ( electronic spark control ) which makes things a little more controled.

No such thing as Points on a sierra unless you go and fit a capri or tina dizzy to a pinto.

CVH and DOHC just have HT distributors with no spark timing control built in. They do need either their correct ESC or EDIS control. or third party spark control

The wiring is easy if you keep the engine loom.

TT

Just fit a bike engine and be done with it, car engines are toooo heavy and saves all that farting about malarky with wires

[les g]

if i was gonna run a pinto on carbs
i would give a lot of consideration to a Bestek (PLEASE GOOGLE)
IGNITION/DIZZY SETUP
for years and years all the f2 stockcar and rally boys have been using
carbs and a bestek ignition approx £200 and they do loads of different advance curves to suit your aplication
hth
cheers les g

[aerosam]

Personally I's stick with the ford EFi system to get you going and on the road. You can always change the setup later.

From experience, i can echo TT in telling you that wiring an EFI pinto lump up is a piece of p1ss.

[twinturbo]

I ran my 24V V6 on the garage floor with just 4 wires for power and earths. Pinto is no different.

TT

[jasongray5]

Originally Posted by twinturbo

Not so, all sierras have at the very very minimum had transistorized ignition amplification. Most carb models run a variation on ESC ( electronic spark control ) which makes things a little more controled.

No such thing as Points on a sierra unless you go and fit a capri or tina dizzy to a pinto.

CVH and DOHC just have HT distributors with no spark timing control built in. They do need either their correct ESC or EDIS control. or third party spark control

The wiring is easy if you keep the engine loom.

TT

I wasnt exclusively talking about seirra's