Cutting Steel Question??

[flyerncle]

If you have a compressor buy an air hacksaw,makes short work of 25x25 box section and not too messy and cheap too.

[TheArf]

Have cut all mine with a Rage3 chopsaw, just make sure you clamp the material securley and it is perfectly safe, oh and dont feed it in too quickly. Its' a great piece of kit

Arfon

[CTWV50]

I have only got a little one but never had any complaints

Thanks again peeps, I'm going to try a good hacksaw and see how I get on. I don't mind hard work as long as the cuts are accurate!

[deezee]

I hired a TCT mitre saw from A-Plant in Wrexham. Cost less than £50 and I cut the whole chassis in a couple of evenings. Sure I had some little pieces lefts over, but I just used a hacksaw for the one or two extra cuts.