Harness mount bosses

[Bonzo]

As luck would have it, I recently spent a few days working on my lathe.

I have been utilising some of my surplus materials kicking about.

Just happen to have 4 sets of harness bosses up for grabs

They have been made from 19mm bright round bar & have been bored n threadded with the required 7/16" UNF thread, 50mm in length.

£7.50 per set inclusive of postage.

Drop me a PM if you are interested.

Failing that, try Saturn or Talonmotorsport, I am sure that either of them will be able to help out

[Davey]

PM sent . I could do with a set.

D.

[Bonzo]

Pm back at you Davy

[gaz05]

Do They have to be 7/16 UNF? I'd like to make my own but only have metric taps.

[Bonzo]

Hi Gaz

Strickly speaking no but they should ideally be threadded with a fine thread & metric fine threadded bolts are a real PITA to get hold of, not to mention expensive.

7/16" UNF bolts have been used for years & has more or less been adopted as the industry standard for seatbelts

If you buy a pair of harnesses new, they will most likely come with 7/16" UNF fixings ( Mine certainly did )

All is not lost mate.

You should be able to pick up a decent 7/16" UNF tap on ebay for not a lot of money

Hope that helps

[Homersdouble]

I'll take a set if they're still going - i'll send pm

Chris

[Bonzo]

No problems Chris

I will stick your name on the last set

Pm sent to you.

If any folk have missed out, drop me a message, happy to help out if I can

Besides, I still have a fair bit of 19mm bar stock here