|
|
|
|
#2
13th April 2011, 08:28 AM
|
||||
|
||||
Hi Jim,
the grp panel will fit over the curved frame but you will need to cut it and add a small section underneath the roll bar mounts at the top of the wheel arch. Aesthetically it is much better to make the mods shown earlier when fitting the rear panel and remove the curved rails. The fuel tank will need altering with a tapered back to fit inside the panel. Regards....Andrew
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH 
|
|
#3
13th April 2011, 07:33 PM
|
|||
|
|||
|
I have modified rear end for GRP tub also. Does anyone have any dimensions for fuel tank? I plan to bring the rear stays down same dimensions as book from the centre line of the chassis, but will locate on the rearmost rail, as do not have round tube as aluminium rear tubs do.
__________________
My Blog : leroysroadster.wordpress.com
|
|
#5
14th April 2011, 09:45 AM
|
||||
|
||||
|
Yes that's the one.
Thanks Ozzy......Andrew
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH
|
|
#6
14th April 2011, 07:42 PM
|
|||
|
|||
|
Excellent, thanks gents
__________________
My Blog : leroysroadster.wordpress.com
|
|
#7
10th May 2011, 08:56 PM
|
|||
|
|||
|
guys just welding the grp conversion on but I can't find the diagram with dimensions to show the height off the build table for the rear most tube etc.
Coudlnt' see the link mentioned above. Scrap that found it, lesson don't try to navigate a website on your Iphone thingy Cheers Mike
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501 Last edited by MikeB : 10th May 2011 at 08:58 PM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
