![]() |
|
#1
|
|||
|
|||
![]() Me too in black
![]() was going to have ago at making one myself, not if someone else is going do it for me. Terry |
#2
|
||||
|
||||
![]() Spud, will these work with an aluminium tub as well? If so i'll happily take one off your hands.
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting ![]() |
#3
|
|||
|
|||
![]() I will defo be getting one of these when I get my bodywork, any ideas on price yet?
__________________
My Blog : leroysroadster.wordpress.com |
#4
|
||||
|
||||
![]() i will have one of them too
Finally something i know anything about in order to get the ground effect you will need to break the airflow up by adding a vertical lip to start the air swirling towards the undertray then the fins speed the air up pulling the rear end towards the floor |
#5
|
|||
|
|||
![]() Vortex generators,also fitted to aircraft wings !!!!
![]()
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. |
#6
|
||||
|
||||
![]() Quote:
Cheers...Andrew
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH |
#7
|
||||
|
||||
![]() I was planning on doing a rear defuser out of carbon fibre.
any news on prices? alsoSpud you have a PM
__________________
My Blog: deannoshaynesroadster.wordpress.com (under construction) Being overtaken is a sign of weakness. South Wales Kit Car Club www.southwaleskitcarclub.co.uk WWW.HELPFORHEROES.ORG.UK XBox Gamer tag: D34NNO |
#8
|
||||
|
||||
![]() I was going to pop in this morning but instead i went to stockton to let real radio smash the wifes ornimental plates
![]() |
#9
|
|||
|
|||
![]() Will this fit with the rear panel section that was made by Triton? Our car is fitted with the full Triton body panels which we purchased back in 2008, we had a few extras done at the time which Triton intended to put into production but don't think they did so it makes our car rather special.
![]() |
#10
|
||||
|
||||
![]() Quote:
|
![]() |
Thread Tools | |
Display Modes | |
|
|