SB2 > D8 fitting problem

[will_08]

Sorry Kev, ive lost the plot, i mean it fits around 500mm from the baseline, something like 9mm longer.

Sorry again

[ozzy1]

Are BR5,BR12,BR6 square to each other?

[K4KEV]

Originally Posted by ozzy1

Are BR5,BR12,BR6 square to each other?

think you might be right ozz.
that would explain a slight discrepancy like 9mm. If you cannot find out where it is Will, I would try and split the difference which would at least leave gaps that would be weldable, not ideal, but a compromise

[will_08]

Thanks again guys, ill have another good check round then go from there. i was thinking myself that the bottom rails might not be true.

Cheers Will

[will_08]

Further to this, ive assembled the rear suspension frame and the side that i had the problems with in this post. is about the same distance short from reaching the cross section. the other side is fine!

I dont have the book with me. to clarfy ive assembled the bottom section, put the uprights on, tacked it 3mm from the edge of BR12. when i put the top assebly on the uprights the left side meets, but the right side there is a gap.



am i right in thinking my base is well wonky?

Should i start again?

Will