|
|
|
|
#2
30th May 2011, 02:32 PM
|
||||
|
||||
Would have just been easier to route the steering arm round the plenum??
|
|
#3
31st May 2011, 08:54 AM
|
|||
|
|||
|
It would have been Steve but because I've got the motor so far back every manifold I've tried on doesn't leave space for a coupling.
There is a manifold out there that only sticks out 180mm from the head but I've had a problem getting hold of one. This is the original Mondeo one.  If this doesn't come out looking decent then I'll have to look at some other method
__________________
Total cost so far Materials £3,150 Tools £855
|
|
#4
31st May 2011, 10:57 AM
|
||||
|
||||
|
Oops, just realised you showed me it before
 Old age eh? What??
|
|
#6
31st May 2011, 09:33 PM
|
||||
|
||||
|
An EFI cast alloy one from an escort or fiesta rs1800 would fit. (don't know if the bonnet would go on though as it goes up and over instead of down like the rest)
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#7
31st May 2011, 11:49 PM
|
|||
|
|||
|
I've recently sold one of those David. It was Huuuuuuge. Would have been way above the bonnet line even without the throttle body.
__________________
Total cost so far Materials £3,150 Tools £855
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
