|
|
|
|
#1
6th June 2011, 06:58 PM
|
||||
|
||||
1x 25ft reel 3/16 copper brake pipe
1 x Tee Piece (3 way union) 4x 10mm x 1mm female union 6x 10mm x 1mm (25mm long) male union Brake pipe flaring tool P clips, 5mm (think it was 4.8) from Maplin 4 x flexi hoses 
|
|
#2
6th June 2011, 07:44 PM
|
||||
|
||||
|
put the pressure sensor in the rear line. i had mine in one of the fronts and it created a pressure imbalance between the two front sides
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/
|
|
#3
7th June 2011, 09:42 AM
|
|||
|
|||
|
Quote:
|
|
#4
7th June 2011, 02:55 PM
|
|||
|
|||
|
are the male unions longer than the standards ones on ebay?
e.g these http://cgi.ebay.co.uk/Male-brake-fit...item4aa96b1dbc or these http://cgi.ebay.co.uk/Male-brake-fit...item4aa96d715a the short ones seem to be standard
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501 Last edited by MikeB : 7th June 2011 at 03:15 PM.
|
|
#5
7th June 2011, 03:32 PM
|
||||
|
||||
|
I used the one from the lower link, I have an assortment of sizes so picked the ones I felt were the correct length.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
