![]() |
#1
|
|||
|
|||
![]() Hi guys and gals,
Was setting up my front suspension yesterday, when turning the camber adjuster on the front upper off side wishbone it snapped. When I inspected it, I think it was one of the worst bits of engineering I've ever seen; made from low grade aluminium and ground down by hand to fit inside the wishbone ![]() Obviously now I need replacements x4 as im going to change them all. The only place I can find them is rally design but theses are made of aluminium, I think they should be made of steel personally. Does anybody know of any other manafacurers of said item? Preferebly made out of steel? Thanks Dan ![]() |
#2
|
|||
|
|||
![]() AshG had one of these go on his roadster whilst driving it, i'm sure he will be along with the answer for you soon.
Terry |
#3
|
||||
|
||||
![]() Just bought a set of these myself for your very reason.Although i dont have them yet to give you a opinion on the quality.
http://cgi.ebay.co.uk/ws/eBayISAPI.d...=STRK:MEWAX:IT |
#4
|
|||
|
|||
![]() Personally I would take the ally adjusters to a machine shop and say "make that out of a good grade steel billet" should not cost to much and will give you piece of mind.
|
#5
|
|||
|
|||
![]() It's more to do with how they are made and what grade of ali was used. Even steel ones could fail if made wrong.
|
![]() |
Thread Tools | |
Display Modes | |
|
|