|
|
#1
19th June 2011, 06:14 PM
|
|||
|
|||
Whats this box
Ok had a look at the Sierra loom this afternoon and I think I'm just going to bin it and do all the wiring from scratch, think I know roughly what to do except dont know waht this box is think it might be electronic ignition as there seems to be a sensor on the crank shaft. I have a 1.8 cvh engine, any ideas anyone konw how to wire it up ?
|
|
#2
19th June 2011, 07:01 PM
|
||||
|
||||
|
not 100% sure but it resembles the EDIS ignition module. the pipe looks like the advance/retard vacuum sensor jobby wotsit
JakeH
__________________
its reight! is not a suitable measurement!
|
|
#3
19th June 2011, 08:05 PM
|
||||
|
||||
|
Keep the engine loom, no point making one. From the ESC-Hybrid it will run round to 2 Multiplugs that hook to the main body loom.
http://www.youtube.com/watch?v=0wmQZOEwR-4
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#4
19th June 2011, 09:15 PM
|
||||
|
||||
|
Do you need to keep the vacuum pipe that goes onto it?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
