|
|
|
|
#1
21st June 2011, 05:52 PM
|
||||
|
||||
No point putting a boot on if the shaft is wrong.
Where did it come from, what's the hub look like? TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders 
|
|
#2
21st June 2011, 06:03 PM
|
|||
|
|||
|
It came off a 1.8 j plate sierra chasseur with rear drums
will put some pics of the hubs later proper got me stumped the drive cup has a ford stamp inside it???
__________________
AJ'S Build
|
|
#3
21st June 2011, 08:12 PM
|
|||
|
|||
|
There are two types of sierra push in shafts as far as I know and that's the later type. They're the same as mine and they came off a "H" plate.
__________________
Total cost so far Materials £3,150 Tools £855
|
|
#4
21st June 2011, 10:43 PM
|
||||
|
||||
|
They differ as well based on engine size, I think 1.3 & 1.6 is different to 1.8 & 2.0 .. I have experience of that but it was circa 1997..
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
