Compound cuts for inlet manifold

		Haynes Forums > Haynes Roadster Forums > General discussion
Compound cuts for inlet manifold

Thread Tools

Display Modes

17th July 2011, 10:07 PM

gus

Senior Member

Join Date: Oct 2008

Location: Taunton

Posts: 174

You need to make a paper wrap to go around the tube . There was a miter tube program you could down load on the forum to help.
Then use a thin cutting disk to cut the tube

Last edited by gus : 17th July 2011 at 10:10 PM.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 11:18 AM.