|
|
#4
2nd August 2011, 07:15 PM
|
||||
|
||||
It's not a difficult thing to make although it is a difficult thing to make look good. It's easier to do if you have a tube type bender for some nice curves and some way of cutting steel sheet straight. Just fill any minor dents or ground down welds with filler.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode