![]() |
#1
|
||||
|
||||
![]() Any idea if IVA man would be happy with me using these clips for holding the fuel lines in place down the tranny tunnel:
http://www.lowcostplumbingsupplies.c...roduct_id=4113 |
#2
|
|||
|
|||
![]() i personally dont know 100% but i would say no due to them being an "open" clip, id imagine they have to be all the way round like the "p" clips
![]() |
#3
|
||||
|
||||
![]() Depends how well they grip the pipe & how far they stand the pipes off the chassis rails ( To avoid chaffing )
Not too dissimilar to OEM pipe clips ![]()
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie ![]() www.roadster-builders.co.uk |
#4
|
|||
|
|||
![]() I think i would agree with michael and say as they are open clips iva tester might not like the open side of the clip
|
#5
|
||||
|
||||
![]() You can get these rubber lined p-clips from Beal Uk Ltd:
http://www.beal.org.uk/hoses-tubing-...prod_1553.html Only £8.80 for 50, much cheaper than CBS, and excellent for the job. IVA man always has a close look along the tranny tunnel and it always goes down well when he sees these plus there is enough to use along the rest of the car. AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH |
#6
|
||||
|
||||
![]() I was a bit worried about them being 'open', probably safer not to use them I guess.
I may have just found an alternative though. I can get hold of these triple clips with two 8mm clamps and one 4.8mm clamp, which should do the fuel lines and the brake line in one go ![]() ![]() Only problem is I have to buy a couple of hundred at a time! |
![]() |
Thread Tools | |
Display Modes | |
|
|