|
|
#33
14th October 2011, 10:52 AM
|
|||
|
|||
I had a go a wiring up a simple ignition circuit for my CVH just using the EDIS module and coil pack
 IMAG0307 by mjb22001, on Flickr  edis4 by mjb22001, on Flickr I did get a spark when cranking the engine over but it seemed a little weak. So i wondered if I had it wired correctly. The black wire is the positive feed to the coil pack and edis. I didnt' have the 25uf suppression to ground fitted as I dont' have whatever a 25uf looks like  Also I wasn't 100% sure on the terminals 1 and 3 on the coil pack The leads and plugs are fairly old also. Any thoughts
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode