Have I created the worst design rear wishbones?

[Tilly819]

I am curious as to why you feel the need to make such a mod, camber can adjusted via the upper wishbone,half track and toe can be adjusted by placing shims behind the bearing block were it bolts up to upright

the load paths arnt great if truth be told

my main concern however is the fact that it appears you are using very low quality rod ends on the most highly loaded wishbone on the hole car

tilly

[Jimmyd]

Originally Posted by Tilly819

I am curious as to why you feel the need to make such a mod, camber can adjusted via the upper wishbone,half track and toe can be adjusted by placing shims behind the bearing block were it bolts up to upright

the load paths arnt great if truth be told

my main concern however is the fact that it appears you are using very low quality rod ends on the most highly loaded wishbone on the hole car

tilly

Why oh why did I not think of shims behind the bearing block. Can't speak for the quality of the rod ends they were there for mock up if I end up finishing this they would be quality items.

[robo]

Originally Posted by Jimmyd

Why oh why did I not think of shims behind the bearing block. Can't speak for the quality of the rod ends they were there for mock up if I end up finishing this they would be quality items.

http://www.westfieldbuild.com/images/Img_0415.jpg

Bob