Suspension brackets on front frame!!

[ozzy1]

I have only put the lower brackets on at the minute but i did a quick mock up and measure this morning but mine seem pretty good for position so

1, my front frame leans back approx 13 deg so check this first.
2, did u make the front frame or was it already made as im sure andy does this part for u in the kit
3, measure from the edge of FF1 out to the edge of FF2/FF3 as this should be 119mm each side.
Is your chassis fully welded cos if you cut the front frame off it is likely to move/spring about.If you do the you will need to tack some braces in to hold everything in place.
( on a side note i made my front frame at least 3 times til i was happy with it !!!)