Saturn Side Panels

[twinturbo]

Originally Posted by wylliezx9r

The triangular part goes underneath. You can then use the fixings of your voice to attach it to the chassis. I used self tappers underneath and countersunk m6 Allen head bolts on top with rivnuts. The cutting template that has been posted is good but is only a guide and not completely accurate, as said before do it in card and offer it up. Hope this helps.

Yep, the cutting guide will need a bit of easing on mine to clear the bolts. But it's fine for first fit.

I had the crescent sections and tried them with the GRP rear tub and they would not fit. So they were cut/bashed off.

If your floor is quit thick then the lower lip may need removing on the side panels.

Having panels on transforms the car

TT

[brainbug007]

Yup I can see me taking the cresent section off as I can imagine they're a total nightmare to fit the tub over. Can't wait to get more of it on over the holidays, just having the nosecone on makes it look amazing

[spud69]

Brian,

The side panels are now made with 2 x 300 gsm matt, rather than 450, and minimally overlapped just to give the sides a bit of extra clearance around the sides of the chassis. So should be okay for those with slightly thicker floor plates.

Your grp conversion tubes are on their way with TNT today so will be with you tomorrow.

Enjoy.....AndyH

[brainbug007]

Brilliant thanks Andy