|
|
#4
29th December 2011, 04:14 PM
|
|||
|
|||
I was having a read up on it as i am butchering ringgears for my flywheel and the general consensus is it needs to be machined from annealed en8. I dont know if thats right but they dont reckon to shave to much off a cast flywheel as it could exit through the bellhousing and give you a rapid pedicure . I will do a bit more research before i order the metal.
Some stuff i found http://www.japspeed.co.uk/Honda-Civi...eel/p-5-1-792/ http://www.axidworks.com/Clutches%20...ed%20Flywheels http://www.hondaperformanceparts.co....l_K_Seri es_/ bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669 Last edited by robo : 29th December 2011 at 05:43 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode