|
|
|
|
#1
10th April 2012, 11:26 AM
|
||||
|
||||
Usually there is a little silver tag on the back cover attached through one of the bolts if u are lucky.The last 3 numbers on the tag will be the ratio ie 362 or 393 etc.
If not take the rear cover off the diff and it is usually etched into the crown wheel(the large one). If not the mark one of the side flanges and then rotate the front drive flange until the side flange does one full rotation.Keep note of how many revolutions you do  
|
|
#2
10th April 2012, 07:52 PM
|
|||
|
|||
|
Divide the number of teeth on the crown wheel by the number of teeth on the pinion and this will give you the ratio to 1,in the abscence of id tags.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
