Exhaust build.

[CTWV50]

Adrian where did you get your pipe bent to spec? Cheers.

[CTWV50]

Originally Posted by AdrianH

I did not, it is bends and bits cut and shut then welded and polished best I can.

Adrian

Ahh I see, good job! What gas did you use? I'm not setup for stainless, is it cost effective for such a small exhaust section? I do know a fabricator quite well maybe I could tack it together and take it to them for full stainless welding Hmm.

[loony]

Originally Posted by CTWV50

Ahh I see, good job! What gas did you use? I'm not setup for stainless, is it cost effective for such a small exhaust section? I do know a fabricator quite well maybe I could tack it together and take it to them for full stainless welding Hmm.

That's how I did exhaust in my last project - tacked with with stainless stick welder and then TIG welded by "professional"... it was much cheaper than custom made exhaust...

[robo]

I am really lucky because my mate is a fine fabs welder for F1 teams and knocks out goodies like this for free. Mind hes had enough of my time








Bob

[CTWV50]

Thanks for the advise I think i have formulated a cunning plan!