Weld finishing

[ozzy1]

Just use a flap wheel in your grinder they are very good for this type of thing.
I use this type because they are free

http://www.ebay.co.uk/itm/10x-115mm-...item3f14bcf7c3

[DaveyB]

Thanks for the reply and link know knew what I am looking for, I think my main concern is the noise of the grinder and upsetting the neighbours I,ll just have to do it in sort bursts.

Thanks again

DaveyB

[will_08]

Dont worry about the noise, it sounds pretty horrendous when your using it.

I was worried till my neighbor borrowed mine and its not half as bad as you would think

[kez_19]

i would leave the welds unless they are in the way of something like a body panel there is no point taking the weld away if you dont need to

[DaveyB]

Hi thanks for your reply I agree it's just that some odd welds are a bit lumpy so I will need to just flash them over a little.

DaveyB

[baz-r]

i was thinking the other day if i had used my tig to do final weld up would i have saved any time after the grind back

[DaveyB]

I wish that I could tig weld the finish looks great from the examples of it that I have seen.
I,ll just stick to my mig for now !

DaveyB