it does exist

[baz-r]

Originally Posted by TalonMotorFabrication

It's a shame your efforts have been let down by the crap panel gaps around the leading edge of the bonnet other wise very well done.

tell me about it! its too short all the way across the top and the radius's are way off with the edge's tight up?
there is nothing in the gap at the front yet. i was a bit panic'y i had mounted the nose or scuttle in the wrong place, chassis dimensions are with in half a mm, nose is tight up and scuttle is smack on
also the bit where the bulge is keeps bowing up i have re shaped it once but it pops backup

i dont want anything ugly poking up above the panel contour or be a diffrent colour to the grp. the other big bulge ones i have seen in the flesh are about the same as mine
sadly i orignaly ordered and wanted a std one but thats a long story i dont want to go over again

i dont know what i can do realy? my only thorts was to make a new one from a sheet of alloy and get it sprayed to match but its not ideal
any one know if anything else fit triton/saturn/nts body?