CP26 plates for MX5

[Numplumb]

Thanks will 08 for your reply I was thinking that they should be thicker, the build guide for them says 3mm though but I think I will use 5mm as you suggest
It only gives dimensions for the hole spacing I was thinking of using 150mm x 361mm x 5mm plates as I can't see any reason why they need to be exact width
The 361mm is the same as RS7 any thoughts?.

Mick.

[Numplumb]

Thanks vmax1974 will try that

[vmax1974]

Originally Posted by Numplumb

Thanks will 08 for your reply I was thinking that they should be thicker, the build guide for them says 3mm though but I think I will use 5mm as you suggest
It only gives dimensions for the hole spacing I was thinking of using 150mm x 361mm x 5mm plates as I can't see any reason why they need to be exact width
The 361mm is the same as RS7 any thoughts?.

Mick.

I think I overlapped the seat back by a few mil just to be sure

[Numplumb]

That's sounds like a good idea
I've PM Gillham about cp plates and have asked about these cp26 plates to get a rough price but haven't given them any sizes for them.