|
|
|
|
#1
28th November 2012, 09:21 PM
|
||||
|
||||
Got me bonny blue paint today, so decided to get the nitromors out to do the rocker covers. Even though the cam bays looked very clean I decided to check behind the breather baffles on the inside of the covers......very glad I did cos it the gunge monster must have just been evicted .....it was caked to hell, so if anyone is using an engine with these type of baffles I would check/clean them out
UUUgghhh.....manky   
|
|
#2
28th November 2012, 11:10 PM
|
|||
|
|||
|
Eww, I'm sure it'l be shiny & bright when your done with it Kev
|
|
#3
1st December 2012, 02:23 PM
|
||||
|
||||
|
not yet shiny DoS but a helluva lot cleaner.
been playing with my mini spray gun again.....these are the water pump and alternator pullys .....colour I mentioned a couple of post ago. got the bottom end built up again but need to alter the depth of my oil pick up, and just waiting for a new oil pump from the USA (£60 cheaper than here, even after postage)   
|
|
#4
1st December 2012, 04:22 PM
|
|||
|
|||
|
Where's the 'Likey' button gone
|
|
#5
1st December 2012, 05:42 PM
|
||||
|
||||
|
Is that the Lydl spray gun?
I picked up one a couple of months back but yet to try it. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#6
2nd December 2012, 10:17 AM
|
||||
|
||||
|
Quote:
http://www.ebay.co.uk/itm/Spray-Gun-...80690192199%26
|
|
#7
3rd December 2012, 01:43 AM
|
||||
|
||||
|
Got the old nitromors to work today and stripped my rocker covers, need to smooth them up a bit and move on to priming them.....have also discovered another cheap tune up mod which is to replace the stock inlet cam for another stock exhaust cam coupled with some vernier pulleys can get an increase in mid range power/drivability
 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
