Time to start a build thread I suppose...

[Oscar]

Heres a close-up of my modded steering bearing mounts:


And, as I believe they're meant to be (though I'm still te be confirmed), the drivers side rear upright/hub/brake arrangement:


Also where the bleed nipple will be as there was some debate about this:


This should be OK as the process of bleeding will push any bubbles out of the bleed pipe, which extends form the top of the cylinder. Calipers are going to be stripped, electrolisysed and put back together with new rubbers.

Think I'll wait to rebuild them untill I'm nearing the point of plumbing all the brakes in as I don't want the internalls to start rusting up before I've filled them will brake fluid.

Please feel free to discuss all elements so far in a polite, sensible and non-judgmental way. (Leave all projectile weapons at the door, hand weapons are fine.)