|
|
#11
15th January 2013, 08:19 PM
|
||||
|
||||
One guy from work has lathe, I draw some sketches and he did for me some parts:
Crush tubes, bush tubes... with DIY polyurethan bushes (I made them myself from two-component polyurethan resin)  It's just an example - I got whole set of them... Front camber adjusters, sleeve tubes and rear camber tubes (?):  DIY sprocket adapter almost ready (SAE1140 flange)...  Need some welding...  ... and then turning/balancing... Tomorrow I plan to weld it but balancing/turning have to wait until water cooled lathe defrost and start to work again... Next week I will have catalytic gas heater - maybe this would help keep me warm while building.
__________________
Lucas ZX9R BEC Haynes Roadster - build cost so far: £1125 My build thread "Whatever you can do or dream you can, begin it. Boldness has genius, power, and magic in it." J.W.Goethe Last edited by loony : 15th January 2013 at 08:29 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode