Rack doesn't fit???

[Talonmotorsport]

Can you measure the hole centres they should be 258mm the two strips that make the jig on my bench are 285 apart, you've got me worried now.....

[Eddy]

I took a photo with a tape against it in case I needed a measurement:



It looks like the centres are less than 258mm, I can measure properly in the morning

[Talonmotorsport]

Well I think it's fairly obvious that the outer edges are 258mm apart not the hole centres. Permission to say 'ooh cock!'

[Eddy]

Permission granted!

[Shorty]

Permission granted phil.

Looks like you will have to cut them off and reweld or cut some new ones, will also need a new diagonal as will be short.

I haven't fully welded mine in yet until I get a rack as there has been a few threads debating the hole centre dimension in the book. if 258mm is correct I will get them fixed tomorrow.

[Eddy]

Yeah, thats what I'll need to do Shorty - Bit of a pain as I wanted to get the front end assembled over the easter break

Have PM'ed Phil to sort out the replacement bits as its a Talon chassis