Stots Build Thread

[twinturbo]

Nice Dials...

TT

[Stot]

Still waiting for some replacement parts so that I can get it rolling and wheel it to and from my other garage but I got the steering hashed out.





The cast UJ from Rally Design is poor. The holes are not in the right position to stop the splined ends from pulling out. Ill try opening them up to allow a bigger bolt or buy the pressed steel version.

Cheers
Stot

[will_08]

Looking good pal,

1 question the plate your steering column bearing is mounted to, is that still 1mm as per the book or have you beefed it up a bit?

I'm just about to tackle that bit is all.

Cheers Will

[Stot]

Originally Posted by will_08

1 question the plate your steering column bearing is mounted to, is that still 1mm as per the book or have you beefed it up a bit?

Its a 3mm piece, 1mm would flex like buggery under braking.

Cheers
Stot

[alga]

Originally Posted by Stot

Its a 3mm piece, 1mm would flex like buggery under braking.

Do you plan to attach your master cylinder or the pedal pivot to it?

[Stot]

Originally Posted by alga

Do you plan to attach your master cylinder or the pedal pivot to it?

I have made up a pedal box so it will bolt in like the book. The CP17 side panel is 1mm on mine. I wouldn't want to be bolting the pedal box to that.

Cheers
Stot

[alga]

Originally Posted by Stot

I have made up a pedal box so it will bolt in like the book. The CP17 side panel is 1mm on mine. I wouldn't want to be bolting the pedal box to that.

Don't forget that the pedal box is also bolted to the floor, it's resting against the bottom chassis rail, and the MC is just a couple of millimetres above said rail. I used 1 mm plate as per book, and I think it's perfectly adequate. If you're unconvinced, 1.5 mm plate will definitely do the job, and 3 mm is just 1 kg of extra weight in the chassis.