AGM Sports Cars Body Kit

[CTWV50]

I've used a Saturn/NTS nose cone and scuttle to use for engine and radiator clearance during my build. Anyone know if the AGM body kit is close in height dimensions to the Saturn stuff or can someone take some measurements for me?

[Davidbolam]

Originally Posted by CTWV50

I've used a Saturn/NTS nose cone and scuttle to use for engine and radiator clearance during my build. Anyone know if the AGM body kit is close in height dimensions to the Saturn stuff or can someone take some measurements for me?

Can you pm me you email address and I will send over their info sheet.

David

[Davidbolam]

Actually if you look at mike b's photo feed he has a copy in there

David

[CTWV50]

Originally Posted by Davidbolam

Actually if you look at mike b's photo feed he has a copy in there

David

Oh yes, thank you David. Think I'm going to sell the bodywork I have and buy a full body kit from AGM. THought long and hard and I've never liked doing/been any good at bodywork!

[Davidbolam]

Originally Posted by CTWV50

Oh yes, thank you David. Think I'm going to sell the bodywork I have and buy a full body kit from AGM. THought long and hard and I've never liked doing/been any good at bodywork!

I am probably going to go for their set as well as I like the way the edges have returns etc. They are also within easy travelling distance for me whereas equinox are a bit far away

David

[CTWV50]

Originally Posted by Davidbolam

I am probably going to go for their set as well as I like the way the edges have returns etc. They are also within easy travelling distance for me whereas equinox are a bit far away

David

Same here colchester(gillham) and Kent (equinox) just a bit far away!

[Ben_Copeland]

Don't be put off by distance. Equinox has a very good delivery company and its top quality bodywork. You won't get better!

[baz-r]

Originally Posted by CTWV50

I've used a Saturn/NTS nose cone and scuttle to use for engine and radiator clearance during my build. Anyone know if the AGM body kit is close in height dimensions to the Saturn stuff or can someone take some measurements for me?

use a merc 190E rad it fits with loads of room

[Ben_Copeland]

Just for reference the Equinox bodykit is about an inch higher than Saturn/NTS so is great for taller engines and obviously normal engines too

[MikeB]

When I was looking I prefered the low line look of the AGM kit and I think its a similar height to the Saturn stuff. I did post a dimension sheet at one point not sure where it is though.

The Equinox stuff is higher so as Ben says is good for taller engines. I prefer the lower look but seeing Ben's car completed it looks pretty good to.