Seat hole positioning

[jps]

Originally Posted by TheArf

Sorry to hi-jack this thread but as it's along the same lines thought I would ask here.
I am fitting my seats using box section is it ok to use rivnuts in the box section or will it be a problem for the I.V.A.
I have got my seats from Robin hood and their seat runners so I have all of the dimensions I need just thought I would check on the suitability

Arfon

I think box section is usually reinforced with crush tubes - which is why I used 3mm flat bar - just seemed simpler. Plus the whole thing will be supported by the floor anyway - so box seemed like overkill...

Still can't see a decent solution other than getting your seats and mocking it all up. It's the only way to be sure it's right...