Jig for camber adjusters on front wishbones?

[Talonmotorsport]

Do the inner threaded sections fit inside the outer sleaves that the arms weld to? It does not matter if the adjusters are longer or wider as long as the bush tubes and the ball joints still fall in the same places as the book ones.

[Joelove]

Originally Posted by Talonmotorsport

Do the inner threaded sections fit inside the outer sleaves that the arms weld to? It does not matter if the adjusters are longer or wider as long as the bush tubes and the ball joints still fall in the same places as the book ones.

Yes they do, I was just concerned about keeping the wishbone arms at the same angle and degrees as the original plans

[TheArf]

Hi Joe,
If you want, you can post them to me, I will machine them to length and dia. for you then if you arrange for collection.
All it will cost you is the postage each way, I will do the machining in work for you

Arfon

[Joelove]

Originally Posted by TheArf

Hi Joe,
If you want, you can post them to me, I will machine them to length and dia. for you then if you arrange for collection.
All it will cost you is the postage each way, I will do the machining in work for you

Arfon

Thank you very much mate for the offer, but my mates making a jig up now as he is fitting camber adjusters now too

[Joelove]

P.s Arfon
I've looked at you photobucket pictures,
How did you get your parts looking so good? What did you use to remove the rust and what paint?
Regards joe

[TheArf]

Electrolysis and a dremmel and long hours in the workshop and hammerite spray paint I also used patio heater lamps to bake the paint off

Arfon

[Joelove]

Originally Posted by TheArf

Electrolysis and a dremmel and long hours in the workshop and hammerite spray paint I also used patio heater lamps to bake the paint off

Arfon

Nice one, I'll give it a go

[alga]

Originally Posted by Joelove

Yes they do, I was just concerned about keeping the wishbone arms at the same angle and degrees as the original plans

I agree with Talon, angles don't matter as long as the attachments are at the right positions relative to each other.