|
|
|
|
#1
13th January 2014, 08:56 PM
|
|||
|
|||
Well done Kevo ! That middle picture reminds me a little bit of a cyclone. I take it a classic mini wiper motor is on the agenda then ?
 it may be easier & safer to flare the bodywork to match the screen than cut it. Lol.Last edited by jason 82 : 13th January 2014 at 08:59 PM. Reason: Missing text 
|
|
#2
14th January 2014, 08:34 AM
|
|||
|
|||
|
When are you fitting a heater ?
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#3
14th January 2014, 05:07 PM
|
||||
|
||||
|
If it's toughend glass you will be very very very very lucky to cut it.
If it's not toughend and not laminated then you will want to deplace it as the fisrt stone hit could send a shard heading in your direction. Will be a custom order job. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#4
15th January 2014, 01:06 AM
|
||||
|
||||
|
Jase.....could be bud then again a sierra bodge could be on the cards
Paul.....as above matey as above tt....me is thinking wet cut diamond tile cutter as I think it is all square underneath.....anyways I have a few tanks to sort oot first and the missus's "list" to get through yet 
|
|
#5
15th January 2014, 07:39 AM
|
||||
|
||||
|
If it's toughened then it will almost certainly 99.99% explode into a million bits. Even with a diamond cutter.
Laminated should be ok if you do a cut accutarly on both sides andthen carefuly break and cut the membrane layer. Plate. Simple enough to cut but I would not want it in any car I was driving. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#6
15th January 2014, 08:44 AM
|
|||
|
|||
|
Chatting to my mate last night and he said that autowindscreens will cut any shape windscreen providing you can give them a template.....unsure of price but could work out cheaper than hassle and hospital appointments
Russ
|
|
#7
15th January 2014, 11:29 AM
|
|||
|
|||
|
If you want toughened glass and its a flat panel then make a template and take it to a glazier.I had one made for my boat for next to nothing. Toughened glass will always have a kite mark or manufacturers mark and is heat treated(tempered) after cutting and edge grinding. Dont even consider trying to cut it.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
