Levelling Rear Fog Light

[twinturbo]

Ventilation duct from B&Q was just right for mine!



TT

[Enoch]

I had similar lights to yours on my build. I just got a flat piece of ally sheet and cut out a shape that was kind of like a rectangle with the two short sides tapering down (imagine a rectangle with a triangle at each side). I then bent them so that I ended up with a hollow wedge that got clamped behind the light. I don't know if that makes any sense at all but it was the easiest way I found to do it and it worked perfectly while adding virtually no weight at all.
Best and all that,
Dave.

[Davidbolam]

Thanks for all of the replies.

In the end I used a method similar to what Enoch said.

I trimmed the lower edge of the fog light slightly and used some aluminium plate at the top to bridge the gap. I then covered the outside with some plastic trim.

It doesn't look too bad either. I will post some more pictures later on my build thread as long as it's not raining!

David