Rosco's haynes Build

[Rosco]

Then got things marked out and started cutting







Front frame done

[Rosco]

I was surprised how quick it started to take shape considering we cut the box as we went along

[Rosco]

Next up the tunnel and cross braces



Then the diff cage

[Rosco]

Got my roll bar bent up yesterday by Tom at www.tube-bender.co.uk, not to far from my house, bent out of 2" cds tube, well pleased with it,
I'm aiming to meet msa spec but not sure if the rear stays can be angled out, I'm going for a full cage but just got the rear hoop until I get my
Scuttle mounted and see what room I've got

It's only clamped on for now as I've got to finish drawing up my parts for laser cutting this week hopefully





And that's about where I'm up to

Thanks for looking

[garyt]

welcome and that's some progress in a week ! there are plenty of helpful minds on here so don't be afraid to ask. if need be.
what engine are you using?
good luck with the build and keep the photos coming
regards gary

[Rosco]

Haha cheers, it has been two weekends! Not sure on engine yet, either an r1 or zx10 I think, I've not really looked into the engine to much, I'm going to get the wishbones made next and try and get some wheels on it

[thailoz]

Great progress well done