![]() |
|
#1
|
|||
|
|||
![]() hi there, been following your build as it as you are using same motor/ bike carb setup as i am, great build so far by the way. I hope you dont mind me asking as I noticed your Hand brake cable set up goes in from the rear, did you do that for any particular reason. It is a pain to position and did you have any issues getting it to seat properly against CP14 as the angle of the brkt would have been better if it was vertical position.
cheers tony |
#2
|
||||
|
||||
![]() Hi Tony, I can't remember why I put the bracket like that, I think it must have been a case of reading the book, welding it in prior to getting my handbrake cable and not having a problem fitting the cable once I eventually bought one.
SeriesLandy, I haven't had a chance to test it yet so I guess I'll need to see how it goes!
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting ![]() |
#3
|
||||
|
||||
![]() Well it's been a long time since I've posted on here! I got very close to finishing the car but decided in the end to cancel my IVA and rebook for early next year so I can get the most of the summer.
My plan to keep me going is to finish the car to a track ready condition, fit a tow bar to my tin top and then do a track day or 2 to give the car a good shake down prior to IVA. It should also spur me on to finish the remainder of the IVA required items! I am currently in the middle of painting the car which is going quite well now that I've got to grips with it. All of my GRP panels except the bonnet have been etch primed, primed and I'm in the process of painting these red. There has been a lot of learning along the way and there will be a bit of work to get rid of a few paint defects like orange peel and a couple of sags. I am hoping to have all of my painting done by the end of September. Once the car is painted there are only a couple of jobs like changing the coolant and oil, putting my racey steering wheel on and checking everything works the way it should. My plan now is to have a track day in the middle of November. I will try and get some more pictures up soon.
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting ![]() |
#4
|
|||
|
|||
![]() Do you know what the rules are for track days and cars without MOT etc? I was looking into this too but wondered how far along my build had to be..
Thanks
__________________
Build photos: http://s1056.photobucket.com/albums/t362/benbrooks1/ |
#5
|
|||
|
|||
![]() Fuel tank vents have been placed up inside the roll bar,cant much higher than that.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. |
#6
|
|||
|
|||
![]() Sounds good!
|
#7
|
||||
|
||||
![]() Ben, I don't think there are any rules on how complete the car needs to be. My boss has a track only Caterham with no MOT, no handbrake and no lights. I think it's a case of as long as it looks safe and nothing is going to fall off I.e. It doesn't look like a shed then I feel it will be ok!
__________________
1.8 Silvertop Zetec (ZX6R Carbs + Megajolt) + Type 9 My Build Blog: http://www.haynes.co.uk/forums/showthread.php?t=2736 - Last Update: 31st October 2020 Total Spent so far: Stopped counting ![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|