front sb's

[old_bill]

I started to fit the front suspension brackets and found that I have a gap between the chassis and the bracket. I have checked the frame dimensions and they seem OK. I had a word with Spikehaus as he had the same problem. There is apparently a thread on this but I can't find it.

Should I place a spacer between the chassis and bracket or should I manufacture new brackets with the dimension to the bracket hole altered to suit?

Thoughts and ideas appreciated

[HandyAndy]

just put a spacer behind the bracket, i too had the same problem.

andy

[mr henderson]

My vote would be for a spacer too. I'm sure you will do something suitable strong, and I think that would be better and more rigid than a bracket with longer arms.

[Bonzo]

As with many others, I too had a gap that required a spacer ( 3mm to be exact )

Checked & double checked the bracket alignment jigs, spot on

As long as the brackets are in alignment with the book spec, all should be fine

Don't shout at me but why not make the front chassis section that much wider to account for the gap.....

[mr henderson]

Originally Posted by fabbyglass

Don't shout at me but why not make the front chassis section that much wider to account for the gap.....

Probably because using spacers would be a lot easier/quicker than going back and redoing the front frame

I would sooner redo the frame section

[HandyAndy]

Originally Posted by fabbyglass

I would sooner redo the frame section

i have thought about this small issue & have looked at how to resolve it in a future build.

andy

[Bonzo]

From the brief bit of head scratching that I done.

It would appear that it is the intersection point at the bottom of the front frame tube & the Two upright tubes that attach to it.

I can't name the parts because I do not have rhe book to hand.

If I were to build another chassis, I would ensure that the front frame was made to suit the brackets.

With the chassis fully welded, altering the front frame was not an option.

[mark]

Originally Posted by old_bill

I started to fit the front suspension brackets and found that I have a gap between the chassis and the bracket. I have checked the frame dimensions and they seem OK. I had a word with Spikehaus as he had the same problem. There is apparently a thread on this but I can't find it.

Should I place a spacer between the chassis and bracket or should I manufacture new brackets with the dimension to the bracket hole altered to suit?

Thoughts and ideas appreciated

It seems as though the person who doesnt need packing behind these brackets is the odd one out on this one!

I did the same as have many others have just pack them out and weld em up!