![]() |
#1
|
|||
|
|||
![]() |
#2
|
||||
|
||||
![]() Gonna have to be cruel Arfon....it just does not look right
![]() |
#3
|
|||
|
|||
![]() Its not cruel Kev as I value opinions what is it your not keen on
Arfon |
#4
|
||||
|
||||
![]() just the indicator looks "flung on"....angled h/l mount is fine after all that how I did my indy..again just my opinion bud
|
#5
|
||||
|
||||
![]() I would say the ofsetting of the indicator looks a Little strange .
Like the aerofoiled tube though TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#6
|
||||
|
||||
![]() What might look fairly cool would be if the indy mounting bolt was used as the same bolt for the up/down movement on the headlight,
|
#7
|
|||
|
|||
![]() Same as kev, something just looks a little odd about the indicator there. If it could be out sideways...
Also, that tube and the raised aspect looks awesome ![]() |
#8
|
|||
|
|||
![]() I see what your saying about the indicator the problem might be that if I send the indicator out to the side it may foul on the cycle wing.
It's easy to remove the indicator the thing I like most is that I managed to get all the wires through the main boss to go down the inside of the arm keeping everything tidy and minimal with the wiring Arfon |
#9
|
||||
|
||||
![]() I've been thinking similar to you, except like the caterham indicators. However I don't think they will go through iva due to being to far in board. It's worth checking the measurements to see if they are ok.
|
#10
|
||||
|
||||
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|