|
|
#1
3rd February 2011, 09:57 PM
|
|||
|
|||
Roll bar horizontal and stays
Picking up 5m of erw tube to complete my roll bar horizontal and stays ..its 38.1mm OD i want to run the rear stays to the lower rear corners and weld them to 100mm x 100 x 3mm plates bolted to plates welded to the tub corners...if that makes sense ...that would give me 16 bolts and allow the roll bar to be removed....my only concern is getting a decent weld between the thin CDS tubing and my roll bar mounting plates...has anybody got any advice ...or even better piccys....sure i have seen this done on one of the many build diarys i have read somewhere !!!
|
|
#2
3rd February 2011, 10:12 PM
|
||||
|
||||
|
Quote:
 , I,ve got some photos, I,ll have a dig about in my photo,s & post up what I have, Just got home & having dinner, so give me an hour or so  cheers andy
|
|
#3
3rd February 2011, 10:19 PM
|
|||
|
|||
|
Did the same as H A and cut holes in the top and lower mounting plates to sit the tube through and weld inside and out.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#5
3rd February 2011, 11:23 PM
|
||||
|
||||
|
Quote:
Just going thru my photos.....theres alot of em   Have you welded in your cross bar into your roll hoop yet? reason I ask is ...it helps if you have the seats at hand to get the height of your harness mounts correct. cheers andy
|
|
#6
3rd February 2011, 11:37 PM
|
||||
|
||||
|
Here.s a couple of pics, hope its what you were looking for ?
  please excuse the wiring was still at the "fitting out " stage.hope it helps. cheers andy
|
|
#7
3rd February 2011, 11:56 PM
|
|||
|
|||
|
Cheers Andy thats exactly my plan....no seats yet so may just tack the cross beam in position until i can afford them...hoping for a set of triton seats ...need to be nice to wifey its my birthday soon !!!
|
|
#8
4th February 2011, 12:05 AM
|
||||
|
||||
|
Quote:
 Triton seats are A1, ......ahhh one day I,ll get some ...I travelled all the way down to the Newark show in Spuds car that has Triton seats, very comfortable, felt fresh as a daisy when we got there .Hope the pics help. cheers andy
|
|
#9
4th February 2011, 12:29 AM
|
||||
|
||||
|
Little tip form lots of experience with roll bars.
what ever you do, make sure you weld the cross bar in before you weld the main rollbar to the mounting plates. if you weld the bar to the plates then weld the cross bar it will pull in and the holes on the plates wont line up with the chassis.
__________________
My Roadster Is Finished NerNer....... Pigs can fly, you just have to carry them onto the plane. My Pictures http://s707.photobucket.com/user/ashgardiner/profile/
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
