|
|
#2
8th June 2011, 06:11 PM
|
||||
|
||||
No reason why self tappers and a blob of locktight would be fine, I'm using rivets but its personal preference.
Last edited by SeriesLandy : 9th June 2011 at 05:40 PM. 
|
|
#3
9th June 2011, 01:22 PM
|
|||
|
|||
|
Less work with rivets,my personal choice.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#5
13th June 2011, 01:36 PM
|
|||
|
|||
|
Hi jack slightly.
I orderd some 4.8mm p clips, they seem a little loose not clamping the brake pipe nothing bad I just expected them to be a nice tight snug fit, is this normal or should I order some more a different size. THe brake pipe is the standard 3/16? copper stuff i had a spare roll in my garage.
__________________
Build Cost so far £xxx (Given up adding it up) - She Starts!! Build Thread Here: http://www.haynes.co.uk/forums/showthread.php?t=5501
|
|
#6
13th June 2011, 02:09 PM
|
||||
|
||||
|
The ones that I got (maplin) have 3/16 printed on them. My pipes were loose enough to slide backwards and forwards. Once you have a few bends/kinks in the pipe it won't move.
btw 3/16 is the correct size for the pipes and m10x1mm unions 25mm long.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
