5 1/2 J X13 alloy wheels for sale

[RAYLEE29]

Personally id say a ton was rather optomistic
theyre mk2 capri ghia wheels
and practically worthless but good luck
Ray

[Davey]

Thanks for the input Ray.

D.

[AshG]

you need minimum of 15's for the roadster so you have a bit of a limited market on her although someone might want them of a different car. may be worth putting them up on locost builders as there are always people looking for a cheep set of 13's for track days

[twinturbo]

Why a minimum of 15's???

TT

[Big Vern]

The haynes roadster was designed around 15" wheels with I think 195/50x15 suggested as the tyre size. So the handling is likely to be best suited to these size tyres. The wheel arches are also designed for these wheels though so long as your rolling diameter is the same as for 195/50x15 then I can see no problem with the wheel arches. ie you could use lower profile 16" or 14" with greater profile - though the handling wont be as sharp as the slip angle increases with increase in profile.
Best bet for those wheels would be to find a Capri or Escort website.
Friend of mine had a set like that on her 3.0S Capri.

BV.

[les g]

theres also clearance issues
cheers les g

[Big Vern]

Well pointed out Les I'd forgotten that - they're likely to be ET 12 or ET19
and the HR will need ET37 - 41
BC.

[frankie boy]

Originally Posted by twinturbo

Why a minimum of 15's???

TT

HI
You need 15” wheels to clear the rear upright. The bolts on the bottom wish bone run very close to the inner wheel rim.

[AshG]

as frankie says its nothing to do with the ofset. its the fact that anything less than a 15inch wheel wont clear the bottom of the rear uprights. you can possibly get 14's on if you use rose joints instead of bushes but its still a squeeze

[RAYLEE29]

You can use 14"s but you have to mod the rear uprights slightly when making them the lower section needs to be shortened by 5mm effectively raising the lower wisbone 5mm giving the necessary clearance
Ray