|
|
|
|
#1
27th February 2011, 01:58 PM
|
||||
|
||||
3mm plate x2 + height of the nut ~8mm + 1mm washer = 15mm so a 20mm bolt would be fine. I think 16mm would be too short.
|
|
#2
27th February 2011, 02:02 PM
|
||||
|
||||
|
/Cool, same again for the stays at the back?
|
|
#3
27th February 2011, 07:36 PM
|
|||
|
|||
|
The Ford upgrade I would think is because of the potential shear forces involved in a stationary object trying to stop a rotating mass and as stated Ford must have got it right.
Over engineered won't hurt........
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#4
27th February 2011, 09:13 PM
|
||||
|
||||
|
Hmm been digging on those two sites and can't see the 10.9 or 12.9 nuts only 8.8 nuts? Will it be ok to use 8.8 nuts with 12.9 bolts?
|
|
#5
27th February 2011, 09:35 PM
|
|||
|
|||
|
Bolt grade is more important,could be wrong but nut does not need marking for IVA and as stated before you dont need a roll bar.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
