Doing up new ball joints

[Bonzo]

Originally Posted by baz-r

there is just no helping some people

Honestly, I meant nothing by my comments Baz

Just thinking from a home workshop point of view, how many folk have access to a selection of metric & imperial fine threaded, plain nuts ?

I have a huge range of old imperial stuff & a fair bit of metric stock too .... So much so that I weighed in, 6 full builders buckets of used fixings during my last trip to the scrappy .... Got hacked off with tipping them out onto the floor looking for a particular fixing, just to find, that's the only one you dont have

Yes of course you are right mate, the simplest way to pull a ball joint up, is with a plain nut
I guess placing a few flat washers under the nyloc comes a close second.