Measurement Needed

[HandyAndy]

From the tip of the most frontal part of the nose to the rear lower edge( longest length of the car ) of the GRP rear tub is 331cm

cheers
andy

[tkpm]

Thanks Andy...

[HandyAndy]

and the widest width is 172cm from extreme outer edge of the rear wings

My pleasure

cheers
andy

ps....I cheated....the question had been asked before, a long time ago & i had replied to that thread too so the answer was in my post history

[CaptainCrash1971]

HAndy, any idea the height of the engine bay from bottom rail to top of bonnet, need to see if my engine will fit without modification.
Cheers

[HandyAndy]

Originally Posted by CaptainCrash1971

HAndy, any idea the height of the engine bay from bottom rail to top of bonnet, need to see if my engine will fit without modification.
Cheers

hang on a mo, I,ll just check my past posts as I,m sure I,ve covered this some time ago too

cheers
andy

[HandyAndy]

You have the height of the chassis from the bottom edge of the lower rails to the top of the upper rails = 355mm,

the top of the bonnet is 230mm above the upper rails at the scuttle end & if my memory doesn,t fail me 171mm above the upper rails at the nose cone

so you have 585mm from base rail to top of bonnet at scuttle end
&
526mm from the base rail to top of bonnet at the nose cone end .

depends which bonnet you fit, as the new Saturn bonnet gives greater clearance in its larger bonnet bulge.

hope that helps.

cheers
andy

[tkpm]

Thanks for the measurements Andy

Have 300mm to spare in lengh and about a 1m in width and still have a decent work area, just need to clear out 14 years worth of junk from my old business.

Terry