|
|
#5
27th August 2011, 09:54 AM
|
||||
|
||||
I think most heater matrixes with out the casing are small enough to hide some where in the chassis, you only need to have a small enclosure to heat passing air. I thought about putting one on the back of the passenger foot well/bulkhead, that way if you have any problems it's only bonnet off not dash and scuttle off. You could always make your own from copper 8-10mm fuel line if you have a radious bender and a few hours to kill. Having said that I've just had a look on fleebay and found this for not alot of money.
http://www.ebay.co.uk/itm/Micro-Heat...item2eb29cb45d http://www.ebay.co.uk/itm/PC-Liquid-...em20bc3f dcfb 
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 Last edited by Talonmotorsport : 27th August 2011 at 10:19 AM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode