Rivetting Fuel Sender?

[tex]

Originally Posted by K4KEV

If you are refering to my method then it is obvious to undo them the same way as they were tightened therefor they would not spin

you need to use nitrile rubber to make a gasket from a gasket supplier - there will be one local to you in the yellow pages. only nitrile rubber is truly petrol proof and not resistant.

the fixings - use countersunk rivnuts - using normal rivnuts leaves the head proud which gets in the way of the face to which you want a seal. the countersunk ones sit flush M6 will do fine with stainless bolts. make sure that all seals mating faces have very very clean faces with no deep scratches - petrol will find a way along it sooner or later.

but please do not use any sealant - it will come loose and drop in the tank - then block your fuel lines and filters - usually while your out..