fixing a steel floor

[twinturbo]

I used a Lazy riviter and it was easy work.

TT

[Eternal]

I went 2mm steel floor and welded it all around in sections. It has a slight ripple but nothing too bad. Tbh i prefer to have the extra strength you can see how it dips in a little.

[thailoz]

Thanks guys good advise


Phil with regards to the Front frame

am I correct in saying you cut ff2 at 13 degrees then weld together once in the jig to keep the faces at 90 degrees

[Talonmotorsport]

Originally Posted by thailoz

Thanks guys good advise


Phil with regards to the Front frame

am I correct in saying you cut ff2 at 13 degrees then weld together once in the jig to keep the faces at 90 degrees

Yes the angles are 13' at the top of FF2 and FF3 with the outer sides 90' to the base of your jig. If you screw/weld two perfect 90' cubes to your jig then clamp FF2 + FF3 to them this will help later when you come to fit your top suspension brackets.

[thailoz]

thanks again I will give the a try

[mgglep]

You may also consider using sealed rivets as these don't let water into the box section